I downloaded and am trying WinMFS Beta Build 9.3f.
I'm running it on a physical Windows 8.1 machine (tried it via USB-SATA on a VM on my Mac and didn't see the drive) and while the drive itself is seen by Windows, WinMFS shows no drives at all for A & B, even when I check Show Mounted Drives.
Following advice in another thread, I made a partition on the 2TB WD20EURX and ensured I could copy data to it. WinMFS still doesn't see it. The drive is connected via internal SATA cable and both the computer and Windows seem to see it and work with it just fine.
I also ran the extended diagnostics off UBCD before I tried any of this - confirmed it has no errors. Also confirmed the Idle Timer is disabled.
I am trying to restore 652m.tbk to this 2TB WD drive, but don't know if I need to do something else to load the image into WinMFS to then place it on the 2TB WD drive.
Am I using an old version of WinMFS? Any other suggestions?
I'm running it on a physical Windows 8.1 machine (tried it via USB-SATA on a VM on my Mac and didn't see the drive) and while the drive itself is seen by Windows, WinMFS shows no drives at all for A & B, even when I check Show Mounted Drives.
Following advice in another thread, I made a partition on the 2TB WD20EURX and ensured I could copy data to it. WinMFS still doesn't see it. The drive is connected via internal SATA cable and both the computer and Windows seem to see it and work with it just fine.
I also ran the extended diagnostics off UBCD before I tried any of this - confirmed it has no errors. Also confirmed the Idle Timer is disabled.
I am trying to restore 652m.tbk to this 2TB WD drive, but don't know if I need to do something else to load the image into WinMFS to then place it on the 2TB WD drive.
Am I using an old version of WinMFS? Any other suggestions?